nedis HQ-INV75W/12 Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
All manuals and user guides at all-guides.com
4) AC output voltage is switched off, caused by overcharging
Ensure that the power used by the connected devices is not
higher than 75 W
5) AC output voltage is switched off, caused by overheating
When the converter has been heavily used during a prolonged
period of time, it will switch off the output current to prevent
possible damage caused by a too high temperature. The led will
light up red. When this occurs do as follows:
(A) Take the converter out of the cigarette lighter plug
(B) Reduce the load of the converter, i.e. disconnect one or more
devices connected to the converter or wait until the converter has
cooled down.
(C) Plug the converter back in the cigarette lighter plug
6) When the battery voltage of the car is too low, under 10V, the
converter will not start. The red led will be lit up.
Charge your battery, hereafter you can use the converter again.
Replacing the fuse
1. Take the converter out of the cigarette lighter plug and remove
the plug of the device that is connected to the converter.
2. Remove the plastic nut at the front and twist it to the left to remove
the fuse.
3. Replace the broken fuse size 5x20mm – 10A Fast
4. Seal the fuse holder.
Technical details
Operating voltage
Output voltage
Output current
Fuse
12 - 13.8V=
220 - 240V ~ 50 Hz
75 W (RMS) / 100 W (Peak)
10A / 250V (Fast)
4

Publicidad

Tabla de contenido
loading

Tabla de contenido