Tally T2024/24 Instrucciones De Servicio página 2

All manuals and user guides at all-guides.com
Important Information
This equipment generates and uses radio frequency energy
and if not installed and used properly, that is, in accordance
with the manufacturer's instructions, may cause interference
in radio and television reception. It has been type tested and
found to comply with the limits for class B computing devices
in accordance with the specification in subpart J of part 15 of
FCC rules, which are designed to provide reasonable pro-
tection against such interference in a residential installation.
However, there is no guarantee that interference will not
occur in a partial installation. If this equipment does cause
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
Reorient the receiving antenna,
Relocate the peripheral away from the receiver,
Move the peripheral away from the receiver
Plug the peripheral into a different outlet, so that the
peripheral and receiver are on different branch circuits
If necessary, the user should consult the dealer or an expe-
rienced radio/television technician for additional sugge-
stions. The user may find the following booklet, prepared by
the Federal Communications Commission, helpful: "How to
Identify and Resolve Radio-TV Interference Problems".
This booklet is available from the U.S. Government Printing
Office, Washington DC 20402 Stock No. 004.000.00345.4.
WARNING: To comply with FCC regulations on electroma-
gnetic interference for a class B computing device, the printer
cable must be shielded. To assure compliance with FCC
regulations for a computing device, use a shielded interface
cable with a metal shell connector. The use of cables not
properly shielded may result in violating FCC regulations.
This digital apparatus does not exceed the class B limits for
radio noise emissions from digital apparatus as set out in the
radio interference regulations of the Canadian department of
communications.
This unit complies with DOC standard C108.8-M 1983
ATTENTION: Le présent appareil numérique n'ement pas
de bruits radioélectriques déspassant les limites
applicables aux appareils numériques de la classe B
prescrites dans le règlement sur le brouillage radio-
électrique édicté par le minstère des communications du
Canada.
The paper used is made of raw materials treated with a
chlorine-free bleaching process.
Das verwendete Papier ist aus chlorfrei gebleichten Roh-
stoffen hergestellt.
Le papier utilisé est fabriqué à partir de matières premières
blanchis sans chlore.
La carta utilizzata è prodotta con materiali sbiancati senza
cloro.
El papel utilizado ha sido fabricado con un proceso de
blanqueo libre de cloro.
WARNING Only trained and qualified personnel may open covers or remove parts that are not explicitly shown and
described in the User Guide as being accessible to the operator.
WARNUNG Das Entfernen oder Öffnen von Abdeckungen und Teilen darf nur durch geschultes Fachpersonal vor-
genommen werden. Ausgenommen hiervon sind nur solche Abdeckungen und Teile, deren Entfernen bzw.
Öffnen in der Bedienungsanleitung ausdrücklich gekennzeichnet und beschrieben sind.
ATTENTION Seul un personnel qualifié et formé est habilité à démonter les sous-ensembles de la machine qui ne sont
pas formellement indiqués dans le Manuel d'utilisation meme s'ils sont accessibles par l'opérateur.
ATTENZIONE Solo personale qualificato puo'accedere a parti che non siano esplicitamente descritte nelle Istruzioni per
l'operatore come accessibill all'operatore.
ADVERTENCIA Las cubiertas y piezas sólo deberán ser quitadas o abiertas por personal especializado. Se exceptúan de
esta regla sólo las cubiertas y piezas cuya retirada y apertura estén indicadas y descritas expresamente en
las Instrucciones de uso.
This device fulfils the European standards requirements by complying with the
Directive of the Commission dated May 3, 1989 (89/336/EEC) relating to elec-
tromagnetic compatibility and the Directive dated February 19, 1973 (73/23/EEC)
relating to low-voltage electrical equipment. Conformity with the above mentioned Direc-
tives is indicated by the CE symbol attached to the device.
Note: Conformity may be affected by:
using interface cables not complying with the specifications
non-observance of important instructions in the operator's manual
installing components not approved for this device by the manufacturer
unauthorized manipulation
Dieses Gerät erfüllt die Anforderungen der Europäischen Normen durch Einhal-
tung der Richtlinie des Rates vom 3. Mai 1989 (89/336/EWG) bezüglich der
Elektromagnetischen Verträglichkeit sowie die Richtlinie vom 19. Februar 1973
(73/23/EWG) bezüglich Elektrischer Betriebsmittel mit Niederspannungen. Die Konformi-
tät zu den oben angeführten Richtlinien ist durch das am Gerät angebrachte CE-Zeichen
gekennzeichnet.
Hinweis: Die Konformität kann beeinflußt werden durch:
Benutzung von nicht spezifizierten Schnittstellenkabeln
Nichtbeachtung wichtiger Hinweise der Bedienungsanleitung
Ersetzen von Bauteilen, die nicht vom Hersteller für dieses Gerät freigegeben wurden
Eingriffe durch Unbefugte
Cet appareil remplit aux exigences des normes européennes en respectant la
directive du Conseil du 3 mai 1989 (89/336/CE) relative à la compatibilité
électromagnétique et la directive du 19février 1973 (73/23/CE) en matière du
matériel à basse tension. La conformité aux directives mentionnées ci-dessus est repérée
par la marque de conformité de la Communauté Européenne (CE).
Remarque: La conformité peut être influencée par:
l'utilisation de câbles d'interface non spécifiés
le non-respect de consignes importantes du manuel d'utilisation
le remplacement de composants qui n'ont pas été homologués pour cet appareil par le
constructeur
l'intervention de personnes non autorisées
Questo apparecchio soddisfa le richieste delle norme europee rispettando la
direttiva del consiglio del 3 Maggio 1989 (89/336/CEE) relativa alla compatibilità
elettromagnetica nonché la direttiva del 19 Febbraio 1973 (73/23/CEE) relativa
a mezzi di produzione elettrici a bassa tensione. La conformità alle direttive sopra citate è
contrassegnata con il simbolo CE applicato sull'apparecchio.
Nota: La conformità può essere influenzata tramite:
Utilizzo di cavi interfaccia non specificati
Inosservanza di importanti indicazioni delle istruzioni per l'uso
Sostituzione di componenti per i quali non è stato dato il benestare dal produttore per
questo apparecchio
Interventi tramite persone non autorizzate
Este equipo corresponde a lo exigido en las normas europeas a base del
cumplimiento de la directriz del Consejo del 3 de mayo de 1989 (89/336/CEE)
en lo que se refiere a la compatibilidad electromagnética así como de la directriz
del 19 de febrero de 1973 (73/23/CEE) en lo que se refiere a los materiales eléctricos con
bajas tensiones. Para señalizar la conformidad con las directrices antes mencionadas, el
equipo está dotado de la marca CE.
Indicación: La conformidad puede estar influida por:
la utilización de cables de interface no especificados
la inobservancia de indicaciones importantes contenidas en el manual de servicio
la sustitución por componentes, que no han sido homologados por el fabricante para
el equipo en cuestión
intervenciones de personas no autorizadas