JOCCA 1590 Manual De Instrucciones página 8

EN English English
NOTE: If the light is on you can select the desired temperature,
temperature range 18-45ºC.
If the light blinks, it indicates open window detection.
- Press the button
Press again and the appliance will turn off, but the fan
continues to run for 30 seconds.
-Pressing the button
temperature.
-The operating time of the appliance can be controlled.
-Press the button
hours.
-Press the button
standby,
temperature range: 18-45ºC.
- If the selected temperature is equal to or lower than the
ambient temperature, the appliance will stop heating.
-To start the set temperature mode press the OK button after
the LED display has flashed for 5 seconds.
-The window open function can only be started when the
appliance is in heating mode (it cannot be started when the
appliance only works with the fan) or in the set temperature
mode.
-Temperature detection starts after 1 minute from the start of
open window detection. This operation is repeated every 5
min.
Note: The weekly timer can only be started when the appliance
is in heating mode (it cannot be started when the appliance
only works with the fan) or in the set temperature mode.
-If there is a power outage, it is necessary to set the current
time.
Setting method:
-The device comes with 6 default programming modes (P1-
P6), to select one of them use the + or - buttons and then
press OK.
Note: If the OK button is not pressed within 10 seconds after
the adjustment, it will give an error.
-The P6 mode is free mode, you can select the days and hours
of operation.
8
and the fan will start.
to
to program the timer from 1 hour to 8
, the temperature setting mode is on
press "+" "-" to adjust the temperature,
select a higher or lower