Background Lighting - DAY 73368 Manual De Instrucciones

Setting the daily alarm
When the time is displayed, press the ALARM
button once. The display shows the alarm
icon (11).
Press and hold the ALARM button for 2
seconds until the alarm time fl ashes.
The hour number of the alarm will fl ash.
Use the "+" and "-" buttons to set the hour.
Press the ALARM button to confi rm the
setting.
The minute number of the alarm will fl ash.
Use the "+" and "-" buttons to set the minute.
Press the ALARM button to confi rm and
conclude the setting.
Briefl y press the ALARM button to switch the
daily alarm on and off .
Note!
After 7 seconds without any button being
pressed, the appliance switches from setting
mode to displaying the time.
The alarm sounds for 2 minutes unless you
press any button to stop the alarm or keep
the SNOOZE/LIGHT button pressed for at
least 2 seconds. In that case the alarm will
repeat automatically after 24 hours.
The volume of the alarm increases in 4 steps
during the 2 minutes the alarm sounds.
Automatic snooze function
Press the SNOOZE/LIGHT button one or more
times while the alarm sounds to activate the
snooze function.
Once the snooze function is activated, the
snooze function icon is shown on the display.
The alarm stops and resumes again after 5-60
minutes.

Background lighting

You can adjust the brightness of the
background lighting in 3 steps or turn it off
by pressing the sun icon button one or more
times.
Displays
Temperature and humidity
The weather station displays the temperature
and relative humidity indoors and outdoors
on the display.
If you press the MEM button once, the
highest values registered since the last reset
will be displayed.
If you press the MEM button twice, the
lowest values registered since the last reset
will be displayed.
If you press the MEM button 3 times, the
current values will be displayed.
If you press and hold the MEM button for
around 2 seconds, the stored values will be
deleted.
If the values are lower or higher than the
weather station's measurement range, LL.L or
HH.H respectively will be displayed.
The arrows in the boxes to the right of the
values indicate if the temperature and
relative humidity are rising, stable or falling.
GB
34