Atlantis BXLEDTV01 Manual De Usuario página 2

To connect strips that shall be placed
separately, use a long 4-pin connector
(joint cables).
Note: 1. Please, note that the sign "+" indicates the direction in which the strips shall be
connected. When connected, the "+" sign of both strips must point at the same direction.
2. Please, do not stick the strips to the TV ventilation area.
FAQs:
The LED strip does not light up once the receiver has been connected and powered on:
1. Check the power input. Please use the supplied USB cable or any other equivalent power
source. The voltage must not exceed 5V.
2. Check if the receiver and the strip are properly connected. Confirm all the components
have been connected properly.
3. Check if the remote control is switched on.
The LED strip is on, but the remote controller is not working or the LED strip does not
respond:
1. Check if the insulation pad has been removed from the remote control.
2. Check if the battery of the remote control has been installed properly.
3. Check if the distance between you and the receiver does not exceed 5m and if the
remote controller is pointing the receiver.
4. Check if batteries need to be replaced.
To connect strips that shall be placed
together, use a short 4-pin connector
(spare joints).