Publicidad
Idiomas disponibles
Idiomas disponibles
27 electrolux safety
The range hood must be connected
with copper wire only.
The range hood should be connected
directly to the fused disconnect (or
circuit breaker) box through metal
electrical conduit.
Wire sizes must conform to the
requirements of the local codes and
ordinances.
Before installing the hood
1. For the most efficient air flow
exhaust, use a straight run or as
few elbows as possible. Vent unit to
outside of building, only.
2. At least two people are necessary
for installation.
3. The hood is fitted with screws and
drywall anchors suitable for most
surfaces, consult a qualified
installer, check if they perfectly fit
with your cabinet/wall.
4. Do not use flex ducting.
5. Cold weather installations should
have an additional backdraft
damper installed to minimize
backward cold air flow and a
nonmetallic thermal break to
minimize conduction of outside
temperatures as part of the
ductwork. The damper should be
on the cold air side of the thermal
break.
The break should be as close as
possible to where the ducting
enters the heated portion of the
house.
All manuals and user guides at all-guides.com
6. Make up air: local building codes
may require the use of make-up air
systems when using ducted
ventilation systems greater than
specified CFM of air movement.
The specified CFM varies from
locale to locale.
Ventilation duct should have exit
towards outside of the building.
Description
7
6
2
2
4
5
3
1
Control panel
2
Lamps
3
Grease filter handle
4
Grease filter
description
electrolux 28
1
2
2
5
Glass
6
Duct covers
7
Louver holes
Publicidad
Capítulos
