iTaste VV Manual Del Usuario página 6

4. Red LED will keep blinking for eight seconds when battery capacity is lower than 3.3V, after which the device will turn
off automatically.
5. Red LED light will stay for five seconds when a load short circuit is detected or the current output of the coil is more
than 3.5A, then no vapor will be produced.
6. If you take a long drag for more than 10 seconds, the battery will stop its output. The RED light will blink 10 times and
the device will not work until it's rebooted.
Notes:
Replace or refill the cartridge if vapor volume decreases.
The manufacturer is not responsible for damaged atomizers, cartomizers or clearomizers.
Driving the device with too much power for too long or may burn out accessories.
We recommend that you start with a low voltage setting and work your way up until when you find the right setting for
your tastes.
Never use your iTaste VV without an atomizer, cartomizer or clearomizer. Connecting to a volt meter without the load
required for high voltages can damage the device.
Although it's made of metal, the iTaste VV can be damaged by dropping. Use appropriate care.
Set lower voltage /wattage for low-resistance (ohms) equipments and higher voltage/wattage for higher-resistance
equipments.
7/EN-7
All manuals and user guides at all-guides.com
CHARGING the iTaste VV
The color of the LED light indicates the remaining
battery life.
or
Plug the USB cable into iTaste VV 's charging
port and a power source.
Recharge iTaste VV with a standard Micro USB
cable. It can also work as a passthrough for
immediate use while charging.
iTaste VV 's button color indicates the charge
level, after fully charged, the LED cut-off.
8/EN-8