How To Use - Steren LAM-030 Manual De Instrucciones

HOW TO USE

1.- Plug the power cord into an AC outlet.
2.- The charge indicator lights on.
3.- Select one or two tubes.
4.- Power on the lamp.
5.- After fi ve minutes, unplug the power cord from the outlet,
simulating a power fail. The lamp should be light on
automatically. The in-use indicator will light on, too.
6.- If you want to turn the lamp off, move the power switch to
OFF (in this mode, the battery will be charging while the lamp is
not ON).
7.- If you want to use the lamp without power cord, just move
the power switch to ON, the battery life time with two tubes is 2
hours and if you use only one tube, you will have approximately
4 hours of time life.
The lamp must be connected to an AC outlet in order to The lamp must be connected to an AC outlet in order to
turns it on automatically when power goes off. turns it on automatically when power goes off.
The charging time and in-use time may vary, depending of The charging time and in-use time may vary, depending of
environment conditions. environment conditions.
SPECIFICATIONS
Input:
Fluorescent tube:
Rechargeable battery: 6V
Time of charging:
Time of use:
Dimensions:
Weight:
Product design and specifi cations are subject to change, Product design and specifi cations are subject to change,
without notice. without notice.
110 V~
24" (18W)
4Ah
20 hours, approx.
1 tube: 4 hours
2 tubes: 2 hours
636x103x99mm
4,4lb approx.
ENGLISH-4
60/50Hz