Warn 102547 Manual De Instalación página 5

13
PRESS SUPER BOLTS STUDS
P
PRESSURE POINTS
A full surface contact between tape and substrate is decisive for good adhesion performance.
In practice a pressure between 40 and 50 N/cm² is usually needed and an application temperature
During application, add-on parts and tapes must have the similar temperature.
DATE: 02.27.19
SUPER BOLT INSTALLATION
A
A
ATTENTION
FOR GOOD
AS MUCH PRESSURE AS POSSIBLE ALL OVER THE
EDGE AND CENTER OF THE SUPER BOLTS STUDS.
SUPER BOLT STUDS
Contact is achieved by applying pressure.
between 25 and 45 °C or 77 and 113 °F is also necessary.
www.warn.com
FORD - RANGER 2019
INSTALLATION MANUAL
ADHESION IT IS NECESSARY TO APPLY
A
A
40-50 N/cm
2
PG. 5