Assembly; Lower Section Assembly; Upper Section Assembly; Connecting The Upper And Lower Sections - Buffalo CC037 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)

Assembly

WARNING: Only connect the appliance to a weatherproof socket designed for exterior
use. If in doubt consult a qualified technician.

Lower Section Assembly

Pass the power cable attached to the base through the first pole section.
1.
Secure the pole section to the base but do not tighten the screw.
2.
Pass the power cable through the second pole section.
3.
Secure the second section to the pole but do not tighten the screw.
4.
Slide the table mounting collar over the pole. Tighten the collar screws when the collar is at the
5.
desired height.
Lower the table top over the pole so it rests on the collar.
6.
Secure it to the collar using the nuts and bolts supplied.
7.

Upper Section Assembly

Pass the power cable attached to the heater through the final pole section.
1.
Secure the pole section to the heater and tighten the screw.
2.

Connecting the Upper and Lower Sections

Connect the two ends of the power cable together.
1.
Connect the two sections together.
2.
Tighten all screws to securely connect all pieces.
3.

Operation

The appliance can be turned On [O] or Off [I] using the switch on the underside of the base.
WARNING: Do not remove any warning stickers attached to the base.
DO NOT attempt to operate the appliance until it is FULLY assembled.
Note: Ensure the appliance is sufficiently upright. A safety tilt switch will cut off the
power should the appliance lean too far or fall over.
Cleaning, Care & Maintenance
• A BUFFALO dealer or qualified technician should carry out repairs if required.
• Always switch off the appliance, disconnect the power supply and allow to cool before cleaning or
performing maintenance.
• If necessary wipe the exterior with a soft cloth and warm soapy water.
All manuals and user guides at all-guides.com UK
2