unwanted object, use the ELIM button. The undesirable object will be eliminated by
the device. It is not recommended to eliminate all objects.
3. COIN MODE
The discrimination range for this mode is designed so that the device can detect all
types of coins and thus eliminate trash such as pieces of metal and foil.
4. ZERO MODE
ZERO mode is the default mode that comes on when the device is turned on. This
mode is used to find all types of coins.
5. PINPOINT MODE [PP]
Once you've found a metal target, you can use PP mode to pinpoint the target.
SOUND SIGNAL
The device is equipped with three kind of beeps for different types of metal. This
makes it easier to identify the detected metal.
Low tone
Medium tone
High tone
Note! The device will emit a loud beep when it detects highly oxidized iron.
Note! The device will emit a medium intensity beep when it detects gold with a purity
of about 15%.
HOW TO USE
1. Turn on the power by pressing the power button once. After about 2 seconds, the
search coil goes into standby mode. The display will show the operating mode
indicators, the sensitivity level and the battery charge indicator. To turn the device
off, press the button again.
Attention! If no button is pressed or no target is detected within approximately 10
minutes, the device turns off automatically.
2. Set the operating mode corresponding to the type of metal you want to search.
3. Set the sensitivity of the device.
4. To test the efficiency of the device, place it on a wooden or plastic table and
remove all metal jewelry (rings, watches, bracelets) from your hands. Position the
search coil so that it is facing the ceiling. If you want to test the device outdoors,
remember that the search coil should be positioned parallel to the substrate, no more
than 5 cm above the ground. Do not use the device in a swinging manner.
Pieces of metal, 1-cent coins, foil, screw caps or pieces of nickel,
aluminum handles, zinc or copper items, 5-cent coins,
10-cent coins, brass or silver items.