Publicidad
Idiomas disponibles
Idiomas disponibles
Safety
-
Wear safety glasses.
-
Keep children and bystanders away while operating the tool.
-
Store the tool out of reach of children and other untrained persons.
-
Tool shall not be used in any application other that the intended use. Any other use is forbidden.
-
Tool cannot be uses in an explosive environment.
Instructions for using rivets
1. Drill a hole in the appropriate location of the workpiece.
2. Select the right draw nosepiece for the rivet.
3. Release the handles.
4. Put the rivet in the draw nosepiece of the riveter and set it in the hole of the workpiece.
5. Tighten the handles. Mandrel will be cut off after 1 or 2 operations.
6. Release the handles and allow the mandrel to drop from the nosepiece.
7. 2,4 to 4,8/5,0 mm, 3/32'' to 3/16'' rivets.
Instructions for using nuts
1. Drill a hole in the appropriate location of the workpiece.
2. Change the draw bar as needed.
3. Release the handles. Screw the draw bar into place with wrench counter-clockwise and fasten the fixing screw.
4. Fasten the nut to the draw bar and set it in the hole of the workpiece.
5. Tighten the handles. If the nut is not tight enough with the workpiece, just release the handles and fasten the draw
bar head, then tighten the handles again.
6. Release the handles and turn the draw bar head to separate the nut and the draw bar.
7. 4 to 6 mm, 1/8'' to 1/4'' nuts.
Nut usage: when you need to add more toughness into the thread of a screw, just take out this nut riveting tool and it
will make your work look fantastic.
2
727819090GBNLFE
GB
v1.0 06112012
Publicidad
