Cleaning The Drain Pump - Proline PFL126 W-F Manual De Instrucciones

GB

Cleaning the drain pump

Drain the water out of the machine and then clean the drain pump.
Please inspect and clean the drain pump regularly.
Never remove the pump cover during a wash cycle. When replacing the pump cover, ensure it
is securely tightened so as to stop leaks.
TROUBLESHOOTING
Problems
The washing machine
will not start.
The door does not open.
Detergent remains in the
detergent drawer after
the programme is
complete.
Washing machine
vibrates or is too noisy.
The washing machine
does not drain and/or
spin.
All manuals and user guides at all-guides.com
Possible Cause
The door is not properly
closed.
Poor connection to the
power supply.
Power failure
Machine has not been
switched on.
Machine safety protection
is working.
The detergent is not a low
suds type.
Excessive use of detergent Reduce amount of
Not all transit bolts have
been removed.
Washing machine is
located on an uneven
surface or is not level.
Machine load is over
5kg(for PFL 105) or
6 kg(for PFL 126) .
Drain hose is blocked.
The filter is locked.
Drain hose end is higher
than 100 cm above the
floor.
Unbalance of the laundry
30
Possible Solutions
Close the door properly.
Check connection to the
power supply.
Check the power supply.
Switch the machine on.
Unplug the machine from
the mains socket.
Check if the detergent is
appropriate.
detergent in the detergent
drawer.
Remove all transit bolts.
Make sure the washing
machine is set on an even
surface and levelled.
Reduce amount of laundry
in the drum.
Unblock the drain hose.
Unblock the filter.
Make sure the drain hose
end is lower than 100 cm
above the floor.
Add clothes or run a
spinning programme again.