Relic Adjust-A-Link ZR11607 Guía Rápida

ENGLISH
Adjust-A-Link - LADIES'
By removing extra links you can size bracelet to fit your wrist.
Lift tab at end of center section on last link.
Open clasp and remove link.
Adjust-A-Link - MEN'S
The Men's Adjust-A-Link instructions work for the following watch styles only:
ZR11607
This procedure should be followed carefully for each link that needs to be removed.
NOTE: Only the above styles can be adjusted with this process.
Hold the watch head in your Look on the inside of the
right hand and the bracelet bracelet. The removable links
clasp in your left hand. are marked with an arrow.
NOTE: Only the above arrow
pattern can be adjusted. Any
other pattern will be damaged
if attempted to adjust.
All manuals and user guides at all-guides.com
ZR15363
Identify the link you want to
remove. Hold that link between
the finger and thumb of your
right hand. Using your left
hand, fold the bracelet to a
90 degree angle.
Using your left hand twist
Once the bracelet is separated,
the link away from the bracelet slide the link to be removed
to remove. (The bracelet must
over into your right hand and
be at a 90 degree angle in twist away from you as before.
order for the link to separate). The link is now removed.
To reattach the bracelet, hold
the links at a 90 degree angle
and push the bar on the right
link into the slot on the left
link. You should feel a click
when the link is attached.
Once the link is in place the
bracelet is ready to be worn.