Thrustmaster 2.1 SOUND SYSTEM Manual Del Usuario

Thrustmaster 2.1 SOUND SYSTEM Manual Del Usuario

Publicidad

THRUSTMASTER
US
RECOMMENDED USE
• Refrain from opening the cabinet as there are sensitive, fragile components inside.
• Unplug the speakers' power cord and disconnect them from your computer before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for cleaning.
• Place the speakers on a flat surface to prevent them from falling.
• Your system should be situated away from heat sources such as radiators, heat registers, stoves or other
products (including amplifiers).
• Do not expose the speakers to fluids, such as chemicals, liquids or water.
D
BETRIEBSHINWEISE
• Nicht das Gehäuse des Lautsprechers öffnen, da es sehr empfindliche Bauteile enthält.
• Zum Reinigen des Lautsprechers muss man ihn zuerst vom Netz trennen und dann am besten mit einem leicht
feuchten Tuch reinigen. Es sollte vermieden werden Flüssigkeiten oder Chemikalien (Sprühreiniger) zu
verwenden.
• Stellen Sie den Lautsprecher auf eine flache Oberfläche, um ein umfallen zu vermeiden.
• Außerdem sollte man den Lautsprecher von Hitze fernhalten so z.B. von Heizungen.
• Setzen Sie die Lautsprecher keinen Flüssigkeiten wie Wasser, chemischen Lösungen und ähnlichem aus.
E
UTILIZACIÓN RECOMENDADA
• Evite abrir los altavoces, contiene componentes frágiles.
• Desconecte los altavoces del sistema antes de limpiarlos. No use liquidos o aerosoles para ello. Use un trapo
limpio y seco.
• Coloca el altavoz en una superficie plana para evitar que se caiga.
• Tus altavoces deben estar situados lejos de emisores de calor tales como estufas radiadores, etc.
• No expongas el altavoz a fluidos, tal como productos químicos o agua.
P
UTILIZAÇÃO RECOMENDADA
• Abstenha-se de abrir as caixas dos altifalantes, pois existem componentes sensíveis e frágeis no seu interior.
• Desconecte os altifalantes do sistema antes de limpá-los. Não use produtos líquidos ou aerossóis. Use um pano
humedecido para a limpeza.
• Coloque os altifalantes numa superfície plana para evitar que caiam.
• O seu sistema deverá estar afastado de fontes de calor, tais como radiadores, reguladores de calor, fogões ou
outros equipamentos (incluindo amplificadores).
• Não exponha os altifalantes a fluidos, tais como produtos químicos, líquidos ou água.
®
QUICK INSTALL

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Thrustmaster 2.1 SOUND SYSTEM

  • Página 1 THRUSTMASTER ® QUICK INSTALL RECOMMENDED USE • Refrain from opening the cabinet as there are sensitive, fragile components inside. • Unplug the speakers’ power cord and disconnect them from your computer before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
  • Página 2: Positioning The Speakers

    POSITIONING ANGABEN ZUR COLOCACIÓN DE POSICIONAR OS THE SPEAKERS POSITIONIERUNG LOS ALTAVOCES ALTIFALANTES speakers Die Lautsprecher und der Los altavoces y el subwoofer Os altifalantes e o subwoofer subwoofer are magnetically Subwoofer sind magnetisch están magnéticamente prote- estão blindados magnetica- shielded and can therefore abgeschirmt.
  • Página 3: Conexión

    CONNECTION ANSCHLUSS CONEXIÓN LIGAÇÃO 1. Turn off your console. 1. Schalten Sie die Konsole aus. 1. Apaga tu consola. 1. Desligue a sua consola. 2. Connect the left (white) 2. Verbinden Sie den linken 2. Conecta el altavoz izquierdo 2. Conecte o altifalante esquerdo speaker connector to the L Lautsprecher (weißen...
  • Página 4: Technical Specifications

    30Hz – 20kHz. © Guillemot Corporation 2002. All rights reserved. Thrustmaster® is a registered trademark of Guillemot Corporation S.A. All other trademarks and brand names are hereby acknowledged and are property of their respective owners. Illustrations not binding. Contents, designs and specifications are subject to change without notice and may vary from one country to another.
  • Página 5: Utilizando Los Altavoces

    USING THE SPEAKERS • Check that the different volume controls (TREBLE, BASS, VOLUME) are set at the minimum level. • Turn on your console, television and speakers (by pressing the POWER button). A green LED will light up. • Set the volume (using the VOLUME button), then set the different parameters (3D, TREBLE, BASS). The 3D button produces 3D sound effects.

Tabla de contenido