Problem Solving; Before Installing - Weitech Bird Gard Pro Guia De Inicio Rapido

PROBLEM SOLVING

Verify what time of day you have set
My device is on but I can't hear any
noise
Verify that you have programmed at
least one bird call to be heard by the
My device is switched on but
You must reset your device by turning
only emits a bird call, always the
same, even though my device is
not programmed to do so.
device is not programmed that
way
Make sure that the switches,
located in "MODE SETTINGS"
are in the correct position.
My device does not work properly
Make sure that the camera's
correctly in DAY or NIGHT mode
light sensor is not obstructed or
not obstructed and not exposed
Check that the battery is still
The device does not work properly when
Switch the device off. Then
connected to a 12 V battery (optional)
reconnect the battery, wait 30
then turn the unit back on.
Checking the volume
to operate the device
by the device
it off completely
for at least 30 seconds
exposed to bright light.
to a bright light source
working
seconds,
B - 1300 Wavre - Belgium info@weitech.eu -
EN
Pest Control Europe sprl Avenue
Mercator, 9
www.weitech.eu
WK 0033 BIRD GARD PRO

BEFORE INSTALLING

The Bird Gard Pro complete kit includes the
control unit with integrated speaker, a
mounting bracket and a transformer. 230V/
12V for the mains. (A battery with assembly
clip is optionally available as well as an
additional speaker that can be plugged into
the fiche provided for this effet at the back of
the unit).
IMPORTANT: Make sure that the power switch
is in the "off" position and that the volume
control is set to minimum (low) (to do this
turn the knob counter-clockwise) (see Fig.1),
before plugging in the unit.
INITIALIZATION AND INSTALLATION
1) Open the transparent cover to set the
recording switches (recording 1-8), and the
operating mode setting switches (mode settings).
See "Programming your BIRD GARD Pro" for a
detailed explanation.
2) It is recommended that the control unit be
mounted on a surface or location that is positioned in the direction
and at the same level as the area to be protected.
3)Use the metal fixing bracket included in the kit (Fig.2), the 2 screws
as well as the 2 washers to fix the control unit to a post, fence, wall
or other surface
4) Connect the transformer. Into a power outlet (or, optionally,
connect the battery cable to the terminals of a 12V battery only).
The other end of the cable should be plugged into the "power" plug
on the back of the control unit.
Fig. 1