Philips 9290031844 Manual De Usuario página 8

1
3
4
4
4
7
8
9
5500K
< 8s
Light ON/OFF
OR
The way of re-coding
Notice: when the product is shipped out from the factory, the remote control has completed the coding and can be used without
pairing. When replacing the remote control or motor driver, it need to be re-pairing.
1. Cut th power, turn off for 5 minutes.
2 Press light button(button 2) within 3 seconds when reconnecting power, then the recoding is completed. It starts to work.
3 If reco ding failed, turn o the power and wait for 1minute before repeating the above operation.
Wireless specification
Wireless RF mode frequency band: 2.4G
Maximum transmitted power: <10dBm
Hereby, Signify declares that the radio equipment type [LED Ceiling Fan Light] is in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following internet address: www.philips.com/lighting
1
6 2
5 3
4
3000K
< 8s
Light ON/OFF
8s 8s
OR
2
4
4
4
5
6
8
10
4000K
< 8s
Light ON/OFF
8s
OR
8
1. Master switch
2. Light ON/OFF
3. Fan OFF
4. Fan speed control:
1-low 6-high
5. Flashlight ON/OFF Always keep
OFF if not use.
6. Clockwise
7. Counter clockwise
8. Timing switch: is used to set
operating hours.
E.g. 2 - sets fan to operate for 2
hours. Press speed button 4 to
cancel the setting.
9. Natural wind flow
(dynamic cycle of speed 1 to 6)
10. Battery:1.5V * 2 AAA
8s
8s
8s