Remote control - no operation
• The batteries may be exhausted. Replace the
batteries.
• The batteries maybe inserted incorrectly. Refer to
the section "Inserting the Batteries into the Remote".
No signal on an input source
• It is possible that no device is connected.
• Check the AV cables and connections from your
device.
• Check the device is switched on.
The Image is not centered in VGA source
To have your TV automatically center the image, enter
the PC Position menu in Picture menu, highlight
Autoposition and press OK. Wait for it to finish. In
order to set the position of the image manually you
can use H Position and V Position options. Select
the desired option and use Left and Right directional
buttons on the remote to set.
Recording unavailable
To record a programme, you should first correctly
connect a USB storage device to your TV, while the
TV is switched off. You should then switch on the TV to
enable recording feature. If you cannot record, check
the storage device is correctly formatted and there is
sufficient space.
USB is too slow
If a "USB disk writing speed too slow to record"
message is displayed on the screen while starting a
recording, try restarting the recording. If you still get
the same error, it is possible that your USB storage
device does not meet the speed requirements. Try
using a different USB storage device.
PC Input Typical Display Modes
The following table is an illustration of some of the
typical video display modes. Your TV may not support
all resolutions.
Index
1
2
3
4
5
6
7
8
9
10
11
12
AV and HDMI Signal Compatibility
Source
EXT
(SCART)
Side AV
PC/YPbPr
HDMI
(X: Not Available, O: Available)
In some cases a signal on the TV may not be displayed
properly. The problem may be an inconsistency with
standards from the source equipment (DVD, Set-top
box, etc. ). If you do experience such a problem please
contact your dealer and also the manufacturer of the
source equipment.
English - 18 -
Resolution
640x480
800x600
800x600
1024x768
1024x768
1280x768
1280x960
1280x1024
1360x768
1400x1050
1600x1200
1920x1080
Supported Signals
PAL 50/60
NTSC 60
RGB 50
RGB 60
PAL 50/60
NTSC 60
480I, 480P
60Hz
576I, 576P
50Hz
720P
50Hz,60Hz
1080I
50Hz,60Hz
1080P
50Hz,60Hz
480I
60Hz
480P
60Hz
576I, 576P
50Hz
720P
50Hz,60Hz
1080I
50Hz,60Hz
24Hz, 25Hz
1080P
30Hz, 50Hz,
60Hz
Frequency
60 Hz
56 Hz
60 Hz
60 Hz
66 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
Available
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O