Operational Start-Up; Assembly - Parkside PRP 400 A1 Traducción Del Manual De Instrucciones Original

GB IE

Operational start-up

Assembly

Fitting the lower aluminium pipe
1. Insert the large sealing ring (15) into the
adapter (11) of the pressure connection.
2. Screw the adapter (11) to the pressure
connection (21) of the pump.
3. Clip the pipe holder (12) with the midd-
le holder to the aluminium pipe. The
mounting rail of the pipe holder (12)
must point downwards.
4. Insert one of the two medium-sized
sealing rings (14) into the screw sleeve
(20).
5. Place an aluminium pipe (19)
onto the adapter (11) and
screw it with the screw sleeve
(20).
6. Push the pipe holder (12) onto the alu-
minium pipe downwards until it enga-
ges in the recess on the device.
Fitting the upper aluminium pipe
1. Connect the lower and upper
aluminium pipe (19) using the
connector (10). Place one of
the small sealing rings (13)
between the connector (10) and each of
the two screw sleeves (18).
Fitting the plastic hook
1 Loosen the wing nut ( 8 ) on the plastic
hook ( 7 ).
2. Remove the screw ( 9 ) from the plastic
handle.
3. Clip the plastic hook ( 7 ) onto the upper
aluminium pipe ( 19 ).
4. Fix the plastic hook ( 7 ) with the screw
( 9 ) and wing nut ( 8 ).
22
Fitting the flexible pipe
1. Insert the medium-sized sealing ring
( 14 ) into the screw sleeve (20) .
2. Push the flexible pipe ( 17 ) onto the
upper aluminium pipe ( 19 ) and screw it
with the screw sleeve (20).
Immersing the pump
Be careful not to hold or hang
the unit by the mains connec-
tion cable. There is a risk of
electric shock due to dama-
ged mains connection cables.
When immersing the pump, make
sure that the shut-off valve(16) is
open to ensure that the pump is ven-
ted.
• Use the plastic hook (7) or attach a rope
to the pump's carrying handle (2) to im-
merse or raise the pump. Never hang
the unit directly from the bent
pipe or water hose.
• You can adjust the height of the plastic
hook after loosening the wing nut (8).
This way you can hang the pump in
a rain barrel without it touching the
ground and sucking in possible sedi-
ment.
• When the water level is low, you can
also place the pump in the rain barrel.
The shut-off valve must protrude over the
edge of the container.
Beware of dirt and sand accumu-
lating at the bottom of the barrel
over time, which could damage the
pump.
We recommend placing the pump on
a brick.