Worx Professional Sonicrafter WU670 Traducción De Las Instrucciones Originales página 10

Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTeNded Use
The power tool is intended for sawing and separating wooden
materials, plastic, plaster, non-ferrous metals and fasteners (e.g.
nails and clamps) as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for working close to
edges and for flush cutting.
Warning: Before working your tool make sure that no
power cords will be damaged. Unplug your tools before mounting
or replacing accessories.
Do not touch the gear box after long working time, because it could
be hot.
1
MOUNTING ACCessORIes (see Fig. A1,A2)
Caution: For all work or when changing application tools, always
wear protective gloves. Avoid danger of injury from the sharp edges
of the application tools. Application tools can become very hot while
working, presenting danger of burns!
Warning: To reduce the risk of injury, do not let the
Universal end cut blades or any segment saw blades face back
toward the user's hand.
Unscrew the fastening piece (8).
Clean the tool holder, the application tool and the fastening piece (8).
Place the application tool exactly onto the hex-shaped tool holder. Note
that the application tool has a flush fit.
reposition the fastening piece (8) using the supplied allen key.
All manuals and user guides at all-guides.com
2
3
8
AdAPTeR (16) (see Fig. A3)
Accessories of other brands( Fein
Sonicrafter ® brand tool using the adapter.
Note: Fein is a registered trademark of C. & E. Fein GmbH. Bosch
®
is a registered trademark of robert Bosch GmbH.
1) Use the allen key (7) to unscrew the fastening piece (8) and then
remove it from the tool holder.
2) Clean the tool holder, the adapter the application tool and the
fastening piece.
3) Fit the adapter onto the tool holder, then place the application tool
onto the adapter. Make sure that the tool holder, the adaptor, and
the application tool share a flush fit.
4) reposition the fastening piece onto the application tool and
tighten with the Allen key.
Note: Make sure the adapter matches the application tool. The
adapter (I) is matched to the application tool of Fein
is matched to the application tool of Bosch
MOUNTING/CHANGING THe sANdING sHeeT (see Fig. B1, B2)
Align the sanding sheet and press it onto the sanding pad by hand.
To ensure optimum Dust extraction device, pay attention that the
punched holes in the sanding sheet match with the holes in the
sanding plate.(See Fig. B2)
Firmly press the power tool with the sanding sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the sanding sheet, turn it 120°
and place it on again.
, Bosch ) can be fitted onto the
® ®
. The adapter (II)
®
® .(See Fig. A3)
®