ICY BOX IB-124CL-U3 Manual página 7

http://www.icybox.de
All manuals and user guides at all-guides.com
4.4 HDD cloning-function (only works when the IB-124CL-U3 is NOT connected
to a PC via USB cable!)
- Before the cloning process, please remove the USB cable from the device.
- Insert the source drive into slot HDD-A (source) and the target drive to slot HDD-B (target).
- Press Power button to power on the device (rear):1 green LED will glow for Power, 2 blue LED for
HDD-A and HDD-B.
- Press and hold the CLONE button for 3 seconds to change to clone mode. Clone Process LED will
flash in blue.
- The first LED of progress indicator (25%) will start to blink as well. The cloning is in process.
- When the status indicator reaches 100% and stops blinking, your cloning process is completed. Press
power button to turn off the power then remove the HDDs.
4.5 Advices to the cloning-function
The clone function creates an identical copy of your hard drive – no need to connect to any computer.
You can copy a bootable system disk without additional software or professional skills.
- Since the cloning process copies every single byte of the source HDD the process may take several
hours depending on the HDD capacity.
- After the cloning process is completed, in some cases the computer may not be able to identify both
drives since they are assigned to the same drive letter. To separate the drives, you must assign one
drive to a new drive letter under "disk management" (Windows).
- If only one drive is plugged into HDD-A (source), there will be no action when you press the start button.
- The target HDD (HDD-B) must be of the same size or bigger than the source HDD (HDD-A).
- You may create a new volume with the remaining space on the target HDD after cloning.
IB-124CL-U3
6 6 6 6