Connecting The Unit; Cleaning Instructions - Telstar TSE020210FH Manual De Instrucciones

CONNECTING THE UNIT

1. Connect the temperature regulator to the base of unit(220-240Vac). Make sure that the plug is connected
properly.
2. Set the temperature regulator to heat level "0".
3. Connect the plug to a socket.
• Preparing food
1. Brush the frying pan with a little cooking oil.
2. Set the temperature regulator to the required heat level. The control lamp will light up to show that the unit
is ready for use (ON).
It takes approximately 5 -10 minutes to heat up the unit and the control lamp goes out. You can then start
cooking the food.
If the food is completely done, you can adjust the temperature to lower or "0" heat level.
• Using the cover
Use the glass cover where possible when cooking all food types. The cover prevents smells from escaping and
reduces cooking time.
The lid knob of glass cover is designed with vents all the way round. It allows condensation from the steam
and the water and also prevents to build up the dirt and grease. It is necessary to unscrew and disassemble
the lid knob for easy cleaning.
NOTE:
• The glass cover has a vent through which hot steam can escape!
• Avoid contact with this escaping steam.
• The cover can become extremely hot during operation therefore use oven gloves, etc. where possible
when removing the cover to avoid burns.

CLEANING INSTRUCTIONS

1. Disconnect the plug from wall outlet, and then remove the power cord connector together with power
cord from the appliance.
2. Allows the unit to completely cool.
All manuals and user guides at all-guides.com
9
ELECTRIC SKILLET
TSE020210FH