1
POWER/ VOLUME
CONTROL
2
MICROPHONE CHARGE
DOCK
3
CHARGE INDICATOR LED
4
LIGHTSHOW
5
ECHO
6
BLUETOOTH INDICATOR
LIGHT
7
BLUETOOTH
8
VOICE EFFECTS
9
WIRELESS ON / OFF
MIC VOLUME CONTROL
Microphone
Turn to power on or off. When powered on, turn to adjust the output
volume.
Place the wireless microphone into the charge dock in the upright
position. Note: In order to charge the microphone, the karaoke
speaker must be plugged in to a power outlet via the USB cable.
Lights up red during charging and goes off when fully charged.
Note: The speaker can be left connected to the charger when off or
in use; it will not overcharge.
Press once for disco lightshow only, press again for mood light only,
press a third time to turn the lightshows off. Press again to turn both
lightshows back on.
Press once for echo, press again to turn the echo off.
Flashes blue when searching for a Bluetooth device to connect to.
Once fully connected to a device the blue light will stay on.
Press once to switch the Bluetooth searching mode on.
Press to cycle through the voice effects. There are 4 voice effects +
normal voice to choose from.
Turn to switch wireless on or off. When wireless is on, turn to adjust
the output volume of the wireless microphone/s. Note: switch off the
Wireless receiver by turning fully anti-clockwise when the mics are
not being used.
10
MICROPHONE
11
LIGHTSHOW
12
POWER SWITCH
13
CHARGE INDICATOR
LIGHT
14
CHARGING POINT
4
Sing clearly in the direction of the top
part of the microphone.
Note: The microphone volume can
only be adjusted from the main
karaoke speaker.
Built – in Lightshow.
Push upwards to power on and
downwards to switch off.
Lights up red when the Microphone is
charging.
Note: To charge the microphone, the
karaoke speaker must be plugged in
to a power outlet via the USB cable.
For charging, make sure the
microphone is placed fully into the
charging dock at the back of the
karaoke speaker.
Note: The Mic charge light and
charge light on the main speaker
should both light up red to indicate
charging mode.