Tool Specifications; Specifications And Technical Data; Instructions For Assembly; Instructions For Operation - Powers 56347-PWR Manual Del Operador

TOOL SPECIFICATIONS

PRODUCT NO.
Pole Accessory (fully assembled)
Length
Weight
Nest module
Length
Weight
Center extension
Length
Weight
Handle module
Length
Weight

INSTRUCTIONS FOR ASSEMBLY

1. Thread the center extension (C) onto the nest
module (D). Hand tighten only.
Figure 2
2. Thread the handle module (A) onto the center
extension (C). Hand tighten only.
NOTE: Periodically check to ensure connections
are tight.
C
NOTE: If optional extension tubes are used the
maximum overall length (including the tool)
should not exceed 13' (3.96 mm).
3. Loosen the locking knob (F) and open the locking
bar (E).
Figure 4
E
56347-PWR
6.7' (2.05 m)
6.0 lbs (2.73 kg)
1.6' (0.49 m)
3.3 lbs (1.5 kg)
3' (0.91 m)
1.3 lbs (0.6 kg)
2.1' (0.65 m)
1.4 lbs (0.63 kg)
C
D
Figure 3
A
F
4. Insert the Powers C5 Fastening Tool into the nest
module, ensure the trigger actuation bar (G) is
positioned in front of the trigger lever.
5. Close the locking bar (E) and tighten locking
knob (F).
Figure 5
F
IMPORTANT: DO NOT use if the nest module or
handle module are damaged. Replace damaged
parts, always use identical replacement parts.

INSTRUCTIONS FOR OPERATION

WARNING: Read the Powers C5 tool
owner's manual and the pole accessory
instructions before use.
1. Load the Powers C5 Fastening Tool as described in
the Powers C5 Fastening Tool owner's manual.
2. Secure your footing and grip the pole accessory
firmly with both hands. One hand on the handle
grip (H, figure 6) and the other hand on the pole.
3. Hold the pole accessory perpendicular to the
material the fastener is being driven into.
CAUTION: DO NOT hold the pole
accessory at an angle, ALWAYS hold
it perpendicular to the material the
fastener is being driven into as shown
in figure 6.
Figure 6
B
H
3
E
G
Figure 7