Eco Operation - Ferroli AMBRA Manual De Instrucciones

ECO function
Press ECO button(some units)

ECO operation:

Under cooling mode, press this button, the remote controller will adjust the temperature
automatically to 24 C/75 F, fan speed of Auto to save energy (only when the set temperature
O
is less than 24 C/75 F). If the set temperature is above 24 C/75 F, press the ECO button,
the fan speed will change to Auto, the set temperature will remain unchanged.
NOTE:
Pressing the ECO button, or modifying the mode or adjusting the set temperature to less
O
than 24 C/75 F will stop ECO operation. O
Under ECO operation, the set tmeperature should be 24 C/75 F or above, it may result in
insufficient cooling. If you feel uncomfortable, just press the ECO button again to stop it.
FP function
2
Note: This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of
17 C/62 F or 20 C/68 F to activate FP function.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
LOCK function
5s
+
Clean
Press ECO button to enter the energy efficient mode.
Note:This function is only available under COOL mode.
O
O
O
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8 C/46 F.
5s
Press together Clean button and Turbo button at the
Turbo
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
O
O
O
O
12