Preparation - Konica Minolta PULSOX-300 Manual Del Usuario

All manuals and user guides at all-guides.com
2. PREPARATIONS
Before starting measurements using this instrument, follow the proce-
dure given below to ensure that measurements are stable.
1) Attaching the Wrist Band
Attach the Wrist Band WB-300 (supplied as a standard accessory) to the
instrument. Since the WB-300 is made of elastic material, it allows for
flexibility and comfortable fitting on the wrist.
Procedure
1 Place the instrument with its rear side up.
2 Pass the angled tip of the hook-and-loop tape of the wristband outward
through band fixture A.
When doing so, make sure that the Velcro tape section faces up-
◆
ward.
3 Fold up the inserted hook-and-loop section, and stick it firmly to the
band.
4 Pass the other end of the band outward through band fixture B.
Take care not to twist the band.
◆
5 Fold back and secure the band with the hook-and-loop tape section.
When attaching the instrument to an arm, adjust the band length and
◆
fitting at this hook-and-loop tape section.
2) Connecting the probe
Connect the probeʼs connector plug to the Probe Connector on the in-
strument.
Make sure that probeʼs connector plug is oriented correctly.
◆
Do not push it in with excessive force. Doing so may damage the con-
◆
nector.
Do not touch the connector terminals by hand. Contact failure may oc-
◆
cur.
3) Installing the battery
Procedure
1 Turn the battery cover clockwise approximately 90 degrees to open
the cover.
When turning the cover, keep the flat part of your finger on the cov-
◆
er's catch. This facilitates opening the cover with minimum force.
E2