Wiring Diagram; Installation Instructions - Home NetWerks 75-101-BT Manual Del Usuario

WIRING DIAGRAM

Mirror

INSTALLATION INSTRUCTIONS

INSTALLING THE Z-BAR FOR HANGING
MIRROR
1. Place the Z-bar (D) at the desired location on
the wall, using a level for final positioning.
Mark the location of the three holes in the
Z-bar (D) on the wall. Drill 1/4 in. holes at
the marked locations and insert included
wall anchors (B). Secure Z-bar (D) to the
wall with three included screws (C).
INSTALL LOWER LOCKING SCREW
2. Using a level mark down from the center of
the Z-bar (D) either 22-3/4 in. for vertical
mirror orientation or 16-7/8 in. for a horizontal
mirror orientation (see FIGURE 1). Drill a
1/4 in. hole at this location and insert an
included wall anchor (B). Drive the lower
locking screw (E) into the anchor (B), leaving
1/2 in. exposed (see FIGURE 1).
www.homewerksww.com
white
black
ground
D
22-3/4"
Vertical mount
3
House
white
black
FIGURE 1
16-7/8"
D
Horizontal mount
D
C
B
E
1/2"