Installation Instructions; Electrical Requirements; Space Requirements - Kenmore 86482 Manual De Uso Y Cuidado

Installation Instructions

Electrical requirements

wWARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Electrical requirements
A 115 Volt, 60 Hz., AC only, 15 ampere fused electrical supply
circuit, properly grounded in accordance with the National
Electrical Code and local codes and ordinances, is required.
It is recommended that a separate circuit, serving only this
appliance, be provided. Use a receptacle which cannot be
turned off with a switch or pull chain.
NOTE: A time delay fuse or circuit breaker is recommended.
Grounding method
For your personal safety, this appliance must be grounded.
This appliance is equipped with a power supply cord having
a 3 prong grounding plug. To minimize possible shock
hazard, the cord must be plugged into a mating, 3 prong,
grounding-type wall receptacle, grounded in accordance with
the National Electrical Code and local codes and ordinances.
If a mating wall receptacle is not available, it is the personal
responsibility of the customer to have a properly-grounded,
3 prong wall receptacle installed by a qualified electrician.
3-prong grounding
type wall receptacle
4
All manuals and user guides at all-guides.com
Ground prong

Space requirements

• To ensure proper ventilation for your ice maker, the front
side must be completely unobstructed. The unit may be
closed-in on the top and three sides, but the installation
should allow the ice maker to be pulled forward for servicing
if necessary.
• Installation of the ice maker requires a cold water supply
inlet of 1 ⁄ " (6 mm) OD soft copper tubing with a shut-off
4
valve and either a gravity-drain system or condensate pump
to carry the water to an existing drain.
• Choose a well ventilated area with temperatures above 55°F
(13°C) and below 110°F (43°C). Best results are obtained
between 70°F (21°C) and 90°F (32°C). This unit MUST be
installed in an area protected from the elements, such as
wind, rain, water spray, or drip.
• When installing the ice maker under a counter, follow the
recommended opening dimensions shown.
NOTE: Do not kink or pinch the power supply cord between
the ice maker and cabinet.
Built-in Opening Dimensions
90°
9" max
(23 cm)
18" (46 cm)
90°
34 1 ⁄ "
2
(88 cm)
Locate
outlet within
this space
4 1 ⁄ " (11.5 cm)
2
To center line