Remote Control; Prepare The Remote Control; Remote Control Buttons; Using The Remote Control To Control The Cursor - Packard Bell Smart TV32 Guía De Uso

UK
R C
EMOTE ONTROL
The remote control is a powerful interface tool that allows you to
Packard Bell Smart TV32
control the
using the Windows XP interface thanks to the gyroscopic cursor

Using the Remote Control to control the cursor

control (see
The remote control may even be programmed with new commands
to allow you to control a set-top box or DVD player from a single
device.

Prepare the Remote Control

The remote control and batteries are individually packed. Before you
can use the remote control please insert the batteries:
1. Remove the battery cover on the remote control, insert the bat-
teries (with the correct orientation) and replace the cover. The
remote control has an effective range of about 10 metres.

Remote Control Buttons

Overview
A. Mode selection, 'Connect' and
Power On/Off
B. Record/Playback controls
C. Menu Navigation controls
D. Gyroscopic buttons (cursor/mouse
controls)
E. Media Center button
F. Volume and Channel controls
G. Media Center shortcuts
H. Alpha-Numeric keypad
I. Teletext and display buttons
Each section is described below.
Using the Remote Control to
control the cursor
The remote control can be used to
control the cursor on the screen, in
much the same way as a mouse.
Hold the remote control flat, with the
buttons facing up and the front towards
the Smart TV32.
Movement
Motion Gyration
Hold the button (pref-
erably with your thumb) and slowly
turn your wrist to the left or right, also
turning the remote control, but keeping it flat. The cursor should
also move to the left and right, following your wrist's movements.
All manuals and user guides at all-guides.com
With a similar movement. twist your wrist up or down to move the
from a distance, even when cursor up or down. Do not move your lower arm.
, below).
Release the
icon or button. This allows the cursor to stay in place while you
reposition your thumb. Press either the right- or left-click buttons (on
either side of the
click.
A
B
C
A. Activates
D
B. Activates
E
F
G
C. Activates
H
D. Press this button to identify the remote control when the receiver
I
E. If in TV/PC mode, this puts the Smart TV32 into Standby mode,
F. Lights when the remote control emits a signal.
Clicking
Motion Gyration button before attempting to click on an
Motion Gyration
button) to perform a right- or left-
Double-click on the Motion Gyration button to use the cursor
control without continuously pressing the button. To return
the remote control to normal operation click once on the
Motion Gyration button (the gyroscopic control will also turn
off if the remote control is inactive for two minutes.)
The Smart TV32 may not enter a power-saving mode if the
gyroscopic control is active.

Using the Remote Control

Mode selection, 'Connect' and
Power On/Off
TV/PC
mode for com-
municating with the Smart TV32
and Windows Media Center .
AUX
mode for commu-
nicating with a second pro-
grammed device, such as a DVD
Programming the
Player. See

remote control

on page 6.
CAB/SAT
mode for
communicating with a third pro-
grammed device, such as a set-top box. See
remote control
on page 6.
is in connect mode (press the 'connect' button on the receiver to
place it in connect mode).
or 'wakes' the Smart TV32 if already in Standby mode. If the
remote control is controlling another device, it will Power on or
off this device.
F
A B C D E
Programming the
Remote Control -
5