Selecting The Operating Mode - EdilKamin 633310 Instalación Uso Y Mantenimiento

sk tecnica TELECOMANDO multilingua cod. 633310.qxp
TEMPERATURE DETECTED BY THE REMOTE CONTROL
The remote control is equipped with an internal sensor to detect the room temperature and display it in real
time.
The detected temperature is transmitted periodically to the control board of the insert/stove if the transmis-
sion LED of the remote control and the receiving sensor of the synoptic panel of the insert/stove are in each
other's field of view.
If the temperature of the remote control does not reach the control board of the insert/stove for over 30
minutes, the temperature detected by the sensor connected to the synoptic panel is used.

SELECTING THE OPERATING MODE

The following functions can be scrolled through and set by briefly pressing the "M" button:
temperature adjustment in automatic mode
manual adjustment of the power
manual adjustment of the ventilation
USING THE "EASY TIMER" PROGRAM
The new remote control allows you to manage a new timer program that is very intuitive and easy to use:
- If the insert/stove is on: a delayed shutdown can be set from the remote control - from one to twelve
hours. The remaining time for the scheduled shutdown is shown on the display of the synoptic panel.
- If the insert/stove is off: a delayed ignition can be set from the remote control - from one to twelve hours.
The remaining time for the scheduled ignition is shown on the display of the synoptic panel.
- Setting: proceed as follows to set the timer:
a)Press the "A" button and the icon
program has been accessed.
b) Set the hours by pressing the +/- buttons, for example:
c) Point the remote control towards the synoptic panel receiver
d) Confirm the setting by pressing the "A" button for a few seconds; the icon
ning time will appear on the synoptic panel after which the "Easy timer" setting will intervene.
e) Repeat points a), b), c), d) to cancel the setting, and set the hours to "00H"
BLOCKED KEYPAD
The remote control buttons can be blocked so as to prevent it from going on accidentally.
Press the A and M buttons simultaneously and the key symbol
have been blocked. Press the A and M buttons simultaneously once again to unblock the keypad.
19/02/2010 11.28
All manuals and user guides at all-guides.com
will light up on the display, thereby confirming the "Easy timer"
6
Pagina 7
will go off and the remai-
will light up confirming that the keys