Trouble Shooting / Warranty - Quality Craft LS5T-H Manual Del Propietário

T R O U B L E S H O O T I N G / W A R R A N T Y
PROBLEM PROBABLE CAUSE
Log is improperly positioned.
The sizes or hardness of the log exceeds
the capacity of the machine
Fails to split logs
Wedge cutting edge is blunt.
Oil leaks.
Unauthorized adjustment was made on
Max. Pressure Limiting Screw. Lower
max pressure rating was set.
The log pusher
Lack of hydraulic oil and excessive air
moves jerkily,
in the hydraulic system.
making unfamiliar
noise or excessive
vibration.
Air sealed in hydraulic system while
operating.
Bleed Screw is not tightened before
Oil leaks around
moving the log splitter.
cylinder ram or
from other points.
Oil Drain Bolt with Dipstick is not tight.
Hydraulic Control Valve Assembly and /
or seal(s) are worn.
WARRANTY
Your electric log splitter is guaranteed for one year. If the tool should stop working within one year from the date of purchase you
should return it to the retailer where you purchased it for a free replacement.
This guarantee is for do-it-yourself / home owner use only and is not valid if the tool is used for commercial or rental use.
The guarantee may not be honoured if in the opinion of Quality Craft, the tool has been misused, dropped, taken apart and or has
been the subject of unusual wear and tear, and/or if repairs have been made or attempted by those other than specified by Quality
Craft. Disassembling the tool will also void the warranty.
IMPORTANT. If you have any problems with your Quality Craft product please vist our website at www.qualitycraft.ca or call cus-
tomer service at 1-800-59-09 before returning unit to the store. Save packaging until you are satisfied with your purchase.
Imported by
Quality Craft Ltd.
Laval, Quebec, Canada H7S G7
1-800-59-09 (EST)
www.qualitycraft.com
Made in China
SUGGESTED ACTION
Refer to "Log Splitter Operation" section
for correct log loading.
Reduce the log size before splitting it on
the log splitter.
Refer to " Sharpening Wedge " section to
sharpen the cutting edge.
Locate leak(s) and contact the dealer.
Contact the dealer.
Check oil level for possible oil refilling.
Contact the dealer.
Loosen Bleed Screw by 3 ~ 4 rotations
before operating the log splitter.
Tighten the Bleed Screw up before
moving the log splitter.
Tighten the Oil Drain Bolt with Dipstick.
Contact the dealer.
9