Logic3 MIP190 Manual De Instrucciones página 2

All manuals and user guides at all-guides.com
POWER
1. Connect the AC Adaptor to the 'AC-12V' connection on the back of the MIP190 and to
your AC mains power socket.
2. Press the button on the top of the unit or the 'I/
control to switch the unit ON / OFF.
SET CLOCK / TIME
1. Switch the unit OFF
2. Press and hold the TIME/SLEEP button on the unit or remote control, the hours display
will begin to flash
3. Press the TUNING/CH ▲▼ buttons on the unit or the 'FF/TUNER+', 'RW/TUNER-'
buttons on the remote control to adjust the hours.
4. Press the TIME/SLEEP button and the minutes display will begin to flash
5. Press the TUNING/CH ▲▼ buttons on the unit or the 'FF/TUNER+', 'RW/TUNER-'
buttons on the remote control to adjust the minutes
6. Press and hold the PRESET/DISPLAY button to switch between 12 and 24 hours clock
mode
7. Press and the TIME/SLEEP button on the unit or the remote control to set the time or if
the unit is left idle for 15 seconds the selected time will be set automatically.
RADIO
1. With the unit switched ON, press the SOURCE button on the unit or remote control to
select the FM or AM Radio mode.
2. To automatically scan through the radio frequencies. Press and hold the TUNING/CH
▲▼ buttons on the unit or the 'RW/TUNER+', 'FF/TUNER–' buttons on the remote
control. The scan will automatically stop when a strong signal is found.
3. To manually scan through the radio frequencies, repeatedly press the TUNING/CH ▲▼
buttons on the unit or the 'RW/TUNER+', 'FF/TUNER–' buttons on the remote control.
4. To adjust the volume press the VOLUME ▲▼ buttons on the unit or 'VOL UP', 'VOL
DOWN' on the remote control.
5. The display will automatically show the set time if the unit is left idle for 5 seconds, to
briefly view the current radio station press the PRESET/DISPLAY button on the unit or
remote control.
6. The unit has a built in FM Antenna, use the aerial wire at the back of the unit for the
clearest possible FM signal.
STORING THE RADIO STATION INTO MEMORY
The MIP190 can store up to 10FM and 10AM radio stations.
1. Select the frequency you want to store into the memory.
2. Press the 'MEMORY' button on the unit or remote control, 'P01' will begin to flash on the
front display. Press the TUNING/CH ▲▼ button on the unit or the 'RW/TNUER-',
'FF/TUNER+' buttons on the remote control to select between presets 'P01'  'P10'.
3. Press the 'MEMORY' button to store the frequency. The display will stop flashing to
indicate the frequency is now stored into the memory.
4. Press the SOURCE button to switch to the AM and FM bands and repeat the above
procedure to store up to 10AM or 10 FM frequencies into the memory.
STANDBY' button on the remote