Uline H-7181 Manual Del Usuario página 2

1. Determine what type of wall board will be mounted on.
2. Measure length, width and center lines of board
and wall. Determine the desired height off the floor
that bottom of board is to be at. Most boards are
mounted about 36" off the floor. (See Figure 1)
Figure 1 Center to Center
Height from Floor to
Bottom Edge of Board
Floor Line
MOUNTING
1. Identify and separate all the parts and hardware.
2. Pick the correct type of mounting hardware and
anchors for wall type.
3. Measure up 1⁄" above the bottom line and draw
another line that is parallel. Measure in about 6"
from each side and install three bottom wall mount
brackets using three CS screws. (See Figures 2-3)
NOTE: The wall mount brackets should be
placed on 16" centers (as a minimum) and not
more than 24".
Figure 2
6"
Wall Mount
CS
Bracket
Screw
PAGE 2 OF 9
of Studs
Board Height and
Width Measurement
Typical Room With Stud Wall Centered Board Layout
1⁄"
Board
Outline
INSTALLATION
3. With help, hold board up in position and draw a line
around the perimeter. Make sure these drawn lines
are parallel with the ceiling and floor.
NOTE: If wall has studs, mount into as many
studs as possible.
Center Line of
Mounting Wall
Center Line
of Board
Figure 3
Stud Wall
Masonry Wall
Drywall Wall
Center to Center
of Studs
Height from Floor to
Bottom Edge of Board
CS Screw
Wall Mount Bracket
CS Screw
Plastic Anchor
Wall Mount Bracket
Drywall Anchor
CS Screw
Wall Mount Bracket
Floor Line
1/8" Predrill
1/4" Predrill
1/4" Predrill
0621 IH-7181