Stopwatch Mode - Uline H-5671 Manual Del Usuario

4. Press D: Change to the next mode.
NOTE: The alarm lasts for 15 seconds and can
be stopped and reset by pressing A. Pressing B
will stop the alarm and start it again.
NOTE: STOP icon will appear in the left corner if
A is pressed while timer is running.

STOPWATCH MODE

The stopwatch can measure up to 10 hours.
0:00'00"00
SPLIT
[000]
Memory
Counter
0:00'00"00
LAP
0:00'00"00
STOP
Before using the stopwatch, be sure to reset the digits to
"0:00'00"00."
• If stopwatch is stopped: Press B.
• If stopwatch is counting, press A to stop the counting
and then press B.
• Press A to start the stopwatch.
SPLIT AND LAP FUNCTIONS
• Split time refers to an elapsed time required to cover
a distance from the start to a given point.
• Lap time refers to an elapsed time required to cover
a given section of the whole distance.
Lap Time
Start
Recording the split and lap times:
• While stopwatch is counting, press B to record
split and lap times on the first and second lines
respectively.
• The stopwatch can store up to 30 split/lap times, as
well as the total elapsed time. The slowest, fastest
and average laps can be recalled, as well as each
individual lap and split time.
PAGE 3 OF 9
MODE SETTINGS CONTINUED
Split Time
Lap Time
Current
Counting Time
Split Time
Recalling the split and lap times:
• The split and lap times can be recalled while the
stopwatch is running or stopped.
• To do so, press C and continue to press C to see all
the desired times.
a. Recalling times with stopped stopwatch: Fastest
lap, slowest lap, average lap and then lap times
are recalled starting with the first lap time.
b. Recalling times with running stopwatch: Fastest lap,
slowest lap, average lap and then lap times are
recalled starting with the most recent lap time.
• Press D to terminate memory recall function.
NOTE: When the memory is full, the memory
counter in the upper left corner will start
flashing. The memory counter will still show
extra split/lap times, but they will not be stored.
CAUTION
• Shocks: Light activities will not affect your watch, but
be careful not to drop your watch or hit it against
hard surfaces, as this may cause damage.
• Magnetism: The stopwatch will not be affected by
magnetism.
• Temperature: Stopwatch will work accurately
between 41°F and 95°F. (Temperatures over 140°F
may shorten the battery life.)
• Low Temperature: Do not store your stopwatch in low
temperatures below 14°F. The cold may cause:
a. A slight time loss or gain.
b. The change of digits to become slow.
c. The display light to become dim.
The above conditions will be corrected when the
watch returns to the normal temperature.
• Chemicals: Be careful not to expose the stopwatch
to solvents (such as alcohol and gasoline), mercury
(i.e. from a broken thermometer), cosmetic spray or
detergents. If exposed, the stopwatch may become
discolored, deteriorated or damaged.
• Static Electricity: The integrated circuit used in your
watch will be affected by static electricity, which
may disturb the display. Keep your watch away from
objects such as TV screens, which emit strong static
electricity.
1-800-295-5510
uline.com
0721 IH-5671