Publicidad
Idiomas disponibles
Idiomas disponibles
ALIGN BOTTOM HANGERS FOR MOUNTING
1.
Determine board location. Measure bottom edge of
board from the floor. Mark with the corner location
for bottom hangers with pencil (A). (See Figure 1)
2. Align bottom hangers with marked line three inches
from each corner of board. Mark screw hole
location at top of slot by arrows (B). Drill 1/4" hole in
marked locations. (See Figure 1)
3. Tap drywall anchors into hole flush to wall with metal
teeth firmly embedded. Turn screw clockwise to
expand metal legs (C). Stop when strong resistance
is felt and legs are fully expanded. (See Figure 1)
4. Remove screw from anchor and re-insert through
top of slotted hole of hanger into drywall anchor (D).
Tighten screw firmly. (See Figure 1)
Figure 1
A
CHECK BULLETIN BOARD IS LEVEL
5. Place board onto bottom hangers (E). Make sure
frame is securely engaged (F). Check that board is
level. (See Figure 2)
NOTE: To reposition hanger, mark corrected hole
location along side of hanger. Use a new anchor.
Figure 2
E
F
PAGE 2 OF 9
MOUNTING
D
C
B
ALIGN TOP HANGERS FOR MOUNTING
6. While holding board flush to wall, mark a pencil line
along back edge of frame near top corners and
middle of board (G). (See Figure 3)
7.
Mark a pencil line along back edge of frame near
top corners and middle of board (H). Remove board
from wall. (See Figure 3)
Figure 3
H
8. Align line indicator of top hangers with marked line
three inches from side edges and middle of board.
Mark precise screw hole location at bottom of slot
by arrows (I). (See Figure 4)
9. Align notches in side hangers with marked line on
sides. Mark screw hole location at end of slot (J).
Install anchors in marked locations using directions
from Steps 1 to 3. (See Figure 4)
Figure 4
G
0521 IH-7810
Publicidad
