Uline H-7030 Manual Del Usuario página 2

3. Hang keyboard-connecting plates onto the four
screws located underneath desktop. Tighten screws
using Allen wrench to fasten the keyboard tray.
(See Figure 4)
NOTE: Before tightening screws, ensure hooks
on keyboard-connecting plates are fully set
into place around the screws.
Figure 4
OPERATING ISSUE
Keyboard rail detaches
If the troubleshooting section does not resolve your problem, contact Uline Customer Service
at 1-800-295-5510.
PAGE 2 OF 6
ASSEMBLY CONTINUED
4. Place devices onto desktop. Use supplied cable ties
Tighten
TROUBLESHOOTING
If keyboard-connecting plates fall off with ball bearing
slides still attached, remove connecting plates from
slides by removing screws.
Reattach slides by inserting them into front of ball
bearing mechanism.
Repeat Step 3 of assembly instructions to reattach
keyboard tray.
1-800-295-5510
uline.com
to fasten cables. (See Figure 5)
CAUTION! Do not place equipment on edges of
desktop.
CAUTION! Leave enough cable length for
height adjustment functions.
Figure 5
RECOMMENDATIONS
0521 IH-7030