Uline H-1843 Instrucciones página 2

CLAMPING AND LIFTING THE DRUM
1. Raise drum grabber clamps above the drum.
Position the ends of clamps on either side of the
drum lid. Do not pass the center line of the drum.
Doing so will cause damage to the drum.
(See Figure 1)
2. Slowly lower the forks to position the drum grabber
clamps in the center of the drum, stopping just
below the raised ring. (See Figure 2)
WARNING! Do not pass the center line of the
drum. Failure to do so will cause damage to
the drum.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
3. Slowly move the fork truck forward to clamp the drum
Figure 1
4. Lift the forks and the drum will be clamped and
LOWERING AND RELEASING THE DRUM
FROM THE DRUM GRABBER
5. Slowly lower the drum onto a firm surface.
6. Continue to lower the forks slowly to open the drum
Figure 2
1-800-295-5510
uline.com
grabber clamps around the drum. (See Figure 3)
lifted. Carry the drum to the desired destination.
grabber clamps. While lowering, slowly move the
forklift backward. (See Figure 4)
Figure 3
Figure 4
0621 IH-1843