Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the bulb
Step 1: Loosen screws that hold lens retaining clips in place .
Step 2: When screws become loose, rotate clips a way from fixture and
remove glass lens.
Step 3: Using gloves or a soft cloth, gently insert bulb by pressing one
end into the spring loaded soc ket and repeat with the opposite
end. Bulb should fit securely into contacts .
Step 4: Replace the glass lens and tighten the screws
that hold the lens retaining clips .
NOTE: Be sure lens gasket is installed correctly around
upper portion of housing (E).
Assembling your fixture
Step 1: Loosen the swivel bolt (F) located on
the back of the fixture.
Step 2: Thread the junction box coverplate
(I) onto the mounting arm (G).
Step 3: Secure the locknut (H) to the
coverplate.
NOTE: Your fixture is factory assembled
for wall or eave mount use. If fixture is
to be used for eave mounting, the screw
holding the mounting arm must be loos -
ened and the mounting arm repositioned
(J). Retighten mounting arm screw when
completed. Be sure fixture is always
mounted in the UP position (note UP
arrow on housing).
Wiring your fixture
Step 1: TURN OFF POWER SUPPLY.
Step 2: Connect the black wire to the black supply wire (hot).
Step 3: Connect the white wire to the white supply wire (neutral).
Step 4: Connect the ground wire to the supply ground or a grounded
junction box. NOTE: Be careful to connect the wires correct-
ly. Make sure no bare strands of wire extend from the wire
nut or other approved wire connector (not provided). Apply
silicone caulk around the junction box to ensure a water-
tight seal.
Step 5: Attach fixture and coverplate to junction box and fasten securely.
NOTE: This fixture can be used with a dimmer switch to adjust
light output. To install a dimmer switch: Use a dimmer switch
designed for incandescent lighting that has a rating of 500 watts
or higher. Follow the installation instructions included with the
dimmer switch. Keeping the halogen bulb in a dim mode for
an extended period of time may shorten the life of the bulb.
E
F
Arm Stop
J
Housing
Stop
Wall or Ground
Mount Position
3
Correct Gasket
Position
H I
G
Housing
Stop
Arm
Stop
Eave Mount
Position
Publicidad
