Kalorik Caiman RVC 40540 Manual De Instrucciones página 7

Aspiradora robótica recargable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

All manuals and user guides at all-guides.com
Fax +1 305 430 9692
CHARGING THE VACUUM CLEANER
Note: Before using your vacuum cleaner for the first time, charge the
battery for approximately 6-8 hours. For every charge after the initial
charge only 4 hours of continuous charge is required to have a full
battery. A fully charged battery will give approximately 55 minutes of
continuous vacuum cleaning.
Place the unit on a flat, horizontal, stable surface that is not
exposed to direct sunlight or humidity.
Make sure the appliance is set to off.
Plug the charger into the charger input (2), and then plug it into a
wall socket.
The Blue LED ring starts blinking, indicating the unit is charging.
Once fully charged, the blue LED ring light will stop blinking and
remain lit.
Caution:
o Do not touch the charger, plug or electric wire with wet
hands.
o Do not use if the connection of the battery is damaged.
o Only use the charger supplied.
Important: The charger and its cord cannot be repaired. Should they
be damaged, they must be discarded. Contact Customer Service to
replace them.
Do not charge the battery if the room temperature falls below 32°F
(0°C) or rises to more than 98°F (37°C).
Other notes and tips:
The charger might get warm during use. This is perfectly normal. It
will cool down as soon as the charging process is over.
When you notice that the motor is turning less quickly, it means
that the battery needs to be charged completely.
It can be useful from time to time (once a month) to completely
discharge the battery, and then completely recharge it, to
maintain optimal performance.
Fully recharge for 4 hours after every use.
Copies of the I/B. Please reproduce them without any
changes
except
under
special
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
7
Assembly page 7/32
instruction
from
Team
Print only
RVC 40540 - 120501

Publicidad

Tabla de contenido
loading

Tabla de contenido