Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself
with its remote control. The following is a brief introduction to the remote control
itself. For instructions on how to operate your air conditioner, refer to the How to
Use Basic Functions
ON/OFF
Turns the unit on or off.
TEMP
Increases temperature in 1°
C (1°F) increments. Max.
temperature is 30°C (86°F).
NOTE: Press together
buttons at the same
time for 3 seconds will
alternate the temperature
display between the °C & °F.
SET
Scrolls through operation
functions as follows: Fresh
( ) > Sleep ( ) > Follow
Me( ) > AP mode (
Fresh...
The selected symbol will
flash on the display area,
press the OK button to
confirm.
TEMP
Decreases temperature
in 1ºC (1ºF) increments. Min.
temperature is 16ºC (60ºF)
FAN SPEED
Selects fan speeds in the
following order: AU > 20% >
40% > 60% > 80% > 100%
Press the TEMP or button to
increase/decrease the fan
speed in 1% increments.
Starts and stops the
horizontal louver move-
ment. Hold down for 2
seconds to initiate vertical
louver auto swing feature.
section of this manual.
&
) >
SWING
Model:
ECRL10B
5
MODE
Scrolls through operation
modes as follows: AUTO >
COOL > DRY > HEAT > FAN
NOTE: HEAT mode is not
supported by the cooling
only appliance.
SLEEP
Saves energy during
sleeping hours.
OK
Used to confirm the selected
functions
TIMER
Set timer to turn unit on or off
SHORTCUT
Used to restore the current
settings or resume previous
settings.
CLEAN
Used to start/stop the Self Clean
or Active Clean function.
(Model dependent, please refer
to the USER'S OPERATION &
INSTALLATION MANUAL).
LED
Turns indoor unit's LED display
and air conditioner buzzer on and
off (model dependent), which
create a comfortable and quiet
environment.
Turbo
Enables unit to reach preset
temperature in shortest
possible time
V.1