Parameters And Specifications - npg DP-708R Manual Del Usuario

• Password
Old Password: Enter the OLD password, (Factory setting is 1369),
and the cursor will jump automatically to NEW PASSWORD.
New Password: Enter the NEW password. Enter 4 digits from the
remote control unit numeric buttons, and the cursor will automatically
jump to CONFIRM PASSWORD.
Confirm Password: Confirm the NEW password by entering it
again. If the confirmation is incorrect, the cursor will stay in this
column. After entering the correct new password again, the cursor
will jump automatically to OK.
OK: Whencursorisonthisbutton,pressENTERkeytoconfirmsetting.
Note:
If the password has been changed, the parentaland disc lock code
will also be changed.
The default password (1369) is always active even the password
has been changed.
• Default:
Back to the factory setttiing.
8 8 7
ENGLISH ENGLISH
All manuals and user guides at all-guides.com
Parameters and specifications
Electronical parameters
Item
Power requirements
Power consumption
Operating humidity
VIDEO OUT
AUDIO OUT
OUTPUT
AUDIO
System
Laser Semiconductor laser, wavelength 650 nm
Signal system NTSC / PAL
Frequency response 20Hz to 20 kHz(1dB)
More than 80 dB (ANALOG OUT connec-
Signal-to-noise ratio
tors only)
Dynamic range More than 85 dB (DVD/CD)
Note:
Design and specifications are subject to change prior notice.
Standard requirement
AC 100-240 V , 50/60 Hz
<10W
5 % to 90 %
1Vp-p(75Ω)
1.4 Vrms (1 KHz, 0 dB)
Speaker:1WX2,Headphones
output