Active Air ACFP2018 Instrucciones De Montaje página 6

Back grill
locking
screws
ASSEMBLY INSTRUCTIONS, cont.
7. Screw the thumbscrew (#24) back in and tighten the locking
screw (#22). This will secure the fan to the stand pole.
8. Remove the outer four back guard locking screw from the
front cover of the motor.
9. Position the back guard(#8) over the motor shaft, fitting the
holes in the back guard over the four screw holes on outside
of the motor. Make sure the handle is at the top.
10. Secure the back guard to the fan motor by screwing in the
four back guard locking screws.
(Image is for reference use only. It might look different from
actual product. )
11. Loosen the blade locking screw (#6) on the pedestal fan
blade. Slide the fan blade onto the mounting shaft with the
shaft sleeve facing the motor. Align securing screw with
flat groove in the motor shaft and tighten with a Phillips
screwdriver.
(Image is for reference use only. It might look different from
actual product. )
12. Remove the small securing bolt (#2) from the bottom of the
front guard (#4). Position front guard so the logo is horizontal
and make sure the guard clips are open. Secure the top tab
to the back guard. Fasten the front and back guards together
with securing bolt (#2) and securing nut (#1). Hold the front
guard against the back guard and snap the guard clips closed
to complete the assembly.
(Image is for reference use only. It might look different from
actual product. )
6