Medicura m281A Manual página 9

Instructions for use
GB
The facial sauna should be used one a week, preferably in the evening,
after removing the make-up. The application may last from 1 to 10
minutes.
Put the sauna on a table or a flat surface.
Pour water into the measuring cup fitted in the main unit up to the MAX
water level.
Set the switch to the "I" position to turn on the appliance.
Put your face on the facial mask when thesteam starts to flow.
Adjust steam flow by rotating the base of the facial mask.
If your hair tends to be frizzy due to humidity, wrap it with a towel during
application.
After every session dry your face gently with a towel and for even better
results, apply a face mask or toner to close dilated pores.
For using the appliance as an inhaler change the facial mask and the
appropriate accessory.
To remove the mask or the inhaler rotate it clockwise and pull it up while
holding the main unit tightly.
After every application, set the switch to the "O" position and unplug the
appliance. Empty the water tank.
Maintenance
GB
Before emptying and cleaning the appliance, always unplug the power
supply cable.
Clean the appliance carefully after every use to avoid greasy substances
and other particles from building up on the surfaces.
Use a slightly damp cloth to clean the main unit.
Do not use any corrosive products or chemical solvents.
NEVER IMMERSE THE APPLIANCE IN WATER.
9