Technical Data; Automatic Operation - HOESCH 6838 Manual

01

Technical data

Dimensions:
Power supply:
Capacity:
02 Assembly
● Place the completely pre-assembled fan from outside on the connection piece of the internal fan plate provided
● Establish the connection using a DN 100 HT pipe.
● N.B. Ensure that the required slope in the direction of extraction is observed.
● N.B. When assembling the fan, ensure that the fan connecting wire is at the top.
GB
When combined with the Hoesch steam generator connect the power supply for the fan in accordance with the assembly
instructions supplied with the steam generator.
03

Automatic operation

There is a possibility to choose one of the three following functions:
Function 1:
Function 2:
Function 3:
Factory setting: Function 1.
4
119 mm x 119 mm (L x W), H = 38 mm
230 V/50 Hz
160 m /h (clearing)
3
6
Exhaust air fan can be switched on or off.
Automatical turning on when "steam bath" function is active. Automatically turning off
10 minutes after turning off the "steam bath" function.
Turning on when steam function is active and temperature in the steam cabin is 2°C lower
than selected temperature.
Always assemble the unit so that the electrical
1
connection is at the top
2
N.B.
3
4
5