Publicidad
Idiomas disponibles
Idiomas disponibles
10. The iron must be used and rested on a stable surface. When placing the iron on its stand, ensure that the
surface on which the stand is placed is stable.
How to fill with water:
Make sure the iron is turned off and the power cord is unplugged from the electrical outlet.
1.
Set the 'Variable' steam knob to the '0' position before filling the iron with water.
2.
Open the 'Water Fill' Opening and fill the Tank up to the 'MAX' Line on the tank.
3.
The water level can be observed through the transparent part of the tank, when iron placed vertically, in
case of water level becomes low, refill the tank, following the procedure described in steps 1 to 3 above.
4.
Pour out the remaining water after use.
Note:
Most tap water can be used in this iron. Do not use water additives or substitute water such as linen or scented
water in the steam iron, they can stain fabrics or damage the iron. Do not fill the water more than the 'MAX'
position.
How to use as dry iron:
1.
Position the iron vertically.
2.
Plug the iron.
3.
Set Steam regulating Knob to MIN position.
4.
Preheat the iron until the indicator light goes out.
Now dry ironing can begin.
How to use the spray:
Before using the spray feature, check the fabric label for ironing instructions because some fabrics may be
spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra dampening is needed.
The spray may be use with steam or dry ironing. Simply pump the Spray Mist knob when spray is desired.
How to use as steam iron:
Fill the iron as described in ' How to fill with water'.
1).
Position the iron vertically and turn the Temperature Control Dial to the steam position.
2).
Plug the Cord into the electrical outlet.
3).Set the Temperature Control Dial to the steam position. Steam Ironing is only possible when at higher
7
STEAM IRON
TPV020910SW
Publicidad
