Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Lower exhaust muffler: Use soapy water to lubricate exhaust rubber hangers. Using
exhaust removal pliers, remove rubber hangers at (3) rearmost locations. Note: Be
sure to support exhaust before removing rubber hangers.
3.
Install hitch: Use wire brush to clean paint and debris from weldnuts. Raise the hitch
into position and secure hitch to vehicle with (3) M12 bolts ① and (3) 1/2" conical
washers ②, both sides, see Figure 1. Note: If necessary, firmly press heat shield up
to keep from contacting top of hitch.
Push heat shield up here
© 2021 Horizon Global™ Corp. - Printed in Mexico
2.
Trim panels: Using tape and marker, sketch a 2" x 2" square on inside corner of
panel under vehicle, both sides. Using die grinder, remove 2" x 2" corner, both sides.
2" x 2"
4.
Tighten all M12 fasteners with torque wrench to 76 Ft.-Lb. (103 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5.
Reinstall the rubber hangers and exhaust muffler.
Sheet 4 of 12
76543NP
2" x 2"
11-08-21
Rev. A
Publicidad
