Burberry Britain Guia Del Usuario página 6

chronograPh
• The chronograph's counter (at 6 o'clock) measures 1/10 seconds, and then
measures hours after 30 minutes.
• The chronograph's minute counter (at 10 o'clock) measures 30 minutes.
• The centre stop-second measures 60 seconds per rotation.
Minute hand
Centre stop-second
Hour hand
Minute counter
1/10 second counter
(hour counter after
30 mintues)
Second hand
PLeaSe note:
Before using the chronograph functions, please ensure that:
• Crown is in position 0 with crown screwed in.
• The three chronograph hands are precisely at zero position following activation of
pusher B. Should this not be the case, the positions of the hands must be adjusted.
See the section entitled "Adjusting the chronograph hands to zero position."
chronograPh: BaSic Function (Start / StoP / reSet)
1. Press pusher A to start the centre stop-second hand.
2. Press pusher A again to stop the timing.
3. Press pusher B to reset the three chronograph hands to zero positioning.
10
Pusher A
Start / Stop
Pusher B
Interval / Reset
chronograPh: intermediate or intervaL timing
1. Press pusher A to start the centre stop-second hand.
2. Press pusher B to stop the chronograph.
note: Although the chronograph hands have stopped, the movement continues
to record the current timing.
3. Make up the measured time: Press pusher B again and the 3 chronograph hands
are quickly advanced to the ongoing measured time. To continue to record
intervals, continue to press pusher B.
4. Press pusher A to stop and the final time is displayed.
5. Press pusher B to reset the three chronograph hands to zero positioning.
adjuSting the chronograPh handS to zero PoSition
1. Unscrew crown to position I.
2. Pull out crown to position III, all three chronograph hands are in their correct or
incorrect zero position.
3. Keep pushers A and B depressed simultaneously for at least 2 seconds, the
centre stop-second rotates by 360° - corrective mode is activated.
4. Press pusher A to single step the centre stop-second hand. Press and hold
pusher A to advance the centre stop-second hand quickly. Press pusher B to
advance to the next hand.
5. Press pusher A to single step the hour counter hand. Press and hold pusher A
to advance the hour counter hand quickly. Press pusher B to advance to the
next hand.
6. Press pusher A to single step the minute counter hand. Press and hold pusher A
to advance the minute counter hand quickly.
7. Push crown back to position I and screw crown until it stops moving (position 0).
Do not change the date between 10pm and 2am. This is when the movement is
in position to carry out the automatic date change, any interference may cause
damage to the movement.
11