Urmet Yokis MTR1300EBRP Manual Del Usuario página 8

Bouton poussoir hybride pour le pilotage d'un éclairage
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
RADIO: CONNECTED DEVICE WITH
PUSH-BUTTON FOR LIGHT
MTR1300eBRP 5454811
Functions
This module can be controlled:
- from the button on the device;
- by one or more additional local buttons;
- radio by remote control
It also allows radio centralisation (with code 5454815 or remote
control) or wired (with code 5454817).
Technical Specifications
Mains voltage:
Power on resistive load:
Module consumption:
Radio frequency band:
Maximum radio power transmitted: 10mW
Sound level:
Ambient temperature:
Relative humidity:
Degree of protection:
Dimensions of buttons (W x H):
Dimensions of module (L x H x D): 22.5 x 50 x 50.5 mm
WIRING
IMPORTANT:
Before starting any configuration, press briefly 23 times to unlock the relay. The module will lock again
automatically after 6 hours. It can also be locked immediately with 21 short presses.
The module must be installed only by qualified personnel and into a place the end-user cannot access, accor-
ding to the installing national rules. In order to follow the safety rules, the module must be connected to a power
line that is upstream protected by a magnetothermic switch 10A C curve.
Centralised
RADIO control
Remote control
Optional
L
N
5454815
Optional
DS1054-064A
Connected device with push-button
for light flush-mounted, 1 module
230V
+10% -15% - 50Hz
~
Max. 1300W
< 1VA - < 0.3W
2400 - 2480 MHz
<60dB a 20 cm
from -20°C to +40°C
0 - 90%
IP30
22.5 x 45 mm
E5
Centralised
WIRED control
E5
5454817
Optional
L
N
Installing Cautions
Optional
pushbuttons
DRIVER WIRE
P8
GB
RAdIO RANGe
POWeR Range (*):
• Inside 100 m² apartments with
perpendicular crossing of main wall or
ceiling
• 250 m in open range
(Note: in both cases the range may be
reduced by the presence of metallic
elements, crossing of walls, or partitions)
RAdIO TRANSMISSION
The transmitter Led will light up only if
the radio transmission was successful.
Adding an intermediate receiver will solve
the problem of an insufficient range.
Refer to the transmitter instruction booklet
for more information.
P1
P2
230V ~
max 1300 W
R1
5454811
Specific
RADIO control
E5
Remote control
Optional

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5454811

Tabla de contenido