Use And Operation - Waldbeck 10031571 Manual Del Usuario

All manuals and user guides at all-guides.com
Before Use
After having read these instructions carefully, you can set your pump to work, reconsidering
the following item:
• Check if the pump rests on the ground of the shaft.
• Check of pressure cord has been attached properly.
• Check if electrical connection is 230 V~, 50Hz.
• Check if socket is in good condition.
• Make sure that water and humidity can never come to the mains supply.
• Avoid pump running dry.
Once you have properly placed and inspected the unit, plug the plug into the socket and the
pump will automatically start.
Automatic Operation
• The ON/OFF switching point can be infinitely adjustment facility. For this purpose you
must first slacken the screw. The switching differential can be infinitely adjusted by ex-
tending or shortening the floating cable.
Before you put the pump into operation, please check the following:
• The float switch must be installed so that the level of the ON operating point and the level
of the OFF operating point can be reached easily and with little force. To check this, place
the pump in a vessel filled with water, raise the float switch carefully by hand and then
lower it again. As you do so, note whether the pump switches on and off.
• Make sure that the distance between the float switch head and the latching holder is not
too small. Proper operation is not guaranteed if the gap is too small.
• When you set the float switch, make sure that it does not touch the base before the pump
switches off. Caution! Risk of dry-running.

Use and Operation

11