MO-EL INSECTIVORO 361 Manual De Instrucciones página 4

Ocultar thumbs Ver también para INSECTIVORO 361:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
GB
IMPORTANT SAFETY INSTRUCTIONS
Please read these instructions before using the INSECTIVORO.
» Remove all packing materials from the unit, to avoid danger of
suffocation, keep it away from babies and children. If received
by mail, install the filters F and H and the trap cover G as show-
nin the drawing.
» Do not use if unit is damaged.
» Do not plug in if the unit is wet.
» Do not use on a wet surface.
» Do not use if cord or plug is damaged.
» Keep cord away from heat.
» Never use outside when wet or expose to moisture.
» Unplug unit when not in use.
» Place INSECTIVORO on furniture, shelf or on the floor, but
always in a vertical position. You can also use the bracket E to
hang the unit on the wall.
» Be sure there is space around the unit for air to circulate.
» Before inserting the plug make sure that the voltage is the
same as indicated on the device.
» Some fundamental rules which apply to all electrical devices
must be observed when using the appliance:
- do not touch the heather with wet hands;
- do not handle with bare feet;
- do not pull the electric cord or the device itself to unplug it
from the socket; pull the plug directly;
- do not let children or incompetent people use device without
supervision.
» This device is intended exclusively for the use for which it was
created, that is the destruction of the flying insects, and the
producer is not responsible for any damage caused by improper
use.
USE INSTRUCTIONS FOR MODELS 361, 363, 368.
Push on/off switches A to the "I" position. The lights and the
fan will turn on. The speed switch B adjusts the speed of the
fan. For low speed: position "I" (quieter, for night use). For
high speed: position "II" (for day use or for larger insects).
Model 368 has only one speed.
Attention: inside model 363 there is a germicidal lamp, which
becomes dangerous in case of direct irradiation. If, for any re-
ason, the lamp becomes visible from the outside, turn it off
immediately and take it to the nearest assistance center. The
germicidal lamp must be cleaned by an authorized technical
assistance center only every 3000 hours of work and replaced
every 8000 hours.
SUGGESTED USE
Position the INSECTIVORO preferably at a height of about 2
meters, placing it in the darkest area of the room, far from win-
dows if mounted permanently.
For use in bedroom turn on the INSECTIVORO at dusk, keeping
shutters or blinds closed, and the device on the night table with
its back, from which air comes out, towards you.
Turn on the INSECTIVORO as early as spring or as soon as the
first troublesome insects appear.
CLEANING AND MAINTENANCE INSTRUCTIONS
Before cleaning make sure that the INSECTIVORO is discon-
nected from the wall socket. INSECTIVORO captures insects and
traps them in the drawer, where they will be dried by the airflow.
Attention: before switching off the unit or before removing the
filter or opening the drawer, make sure there are no dangerous
insects still alive inside. In this case, keep the unit powered ON
until they die.
Empty and clean out the trap I every few days. To clean it pull
it out, empty into trash and wash with running water. Please
use caution when emptying the drawer; make sure the insects
(especially stinging insects) are inactive.
The INSECTIVORO is equipped with a patented drawer cover G
that closes when it is removed from the device and opens when
it is replaced. If you notice that useful insects have been cap-
tured (e.g. honey bees), take out the drawer, place it in the
open, slide open the door L so that they can go free, and move
away.
To clean the filter F, every few days pull on the tab and it will
slide out easily. Clean it under running water.
To clean the exterior, wipe off with a damp cloth. Do not im-
merse in water. Do not use a solvent.
MOUNTING UNIT TO THE WALL
Included with your INSECTIVORO is a special mounting bracket
E for mounting the unit to the wall.
Locate a suitable position. The wall should be free from ob-
structions on the sides of the unit, to allow easy removal of
the trap and filter for cleaning. Make sure there is an electrical
outlet nearby and the area is dry and protected from moisture.
Remove the plastic wall anchor from the wall mounting screw E.
On the wall where you plan to mount the appliance, make sure
that the wall is solid or that you locate stud to provide adequa-
te support for the screw and that no electric wires are passing
through. Using a 5/16-inch drill bit, drill a hole 1-1 / 2 inches
into the wall. Insert the plastic wall anchor into the hole. Next
screw the wall mounting screw into the anchor.
Once the screw is securely mounted into the wall, hang the
INSECTIVORO by hooking the indentation in the plastic on the
upper lip of the back of the appliance onto the bracket.
REPLACING FLUORESCENT BULBS
For maximum efficiency replace the bulbs every 2000 hours.
For replacing the round bulb you must contact your dealer or an
authorized technical assistance center.
ORDERING REPLACEMENT BULBS
The florescent ultraviolet bulbs in your INSECTIVORO have been
designed for maximum attraction to flying insects. Do not re-
place original Ultraviolet fluorescent bulbs with normal lighting
bulbs. Original replacement bulbs are available from your dealer.
TECHNICAL ASSISTANCE
If you have questions regarding your INSECTIVORO call your
dealer. In case of breakdown, malfunction or damage turn the
device off and take or send it to the nearest assistance center.
Repairs must be done by an authorized technical assistance
center usingoriginal parts.
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Insectivoro 363Insectivoro 368

Tabla de contenido